retiredusarmy
Guest
|
 Posted:
Sat Jul 23, 2005 4:42 am Post subject:
Sanyo remote codes |
|
|
I was given two sharp vcrs this week. My Sanyo U100 remote operates them.
However, the Sanyo U110 does not operate them. Only three codes listed on
website 239, 229, and 224. Anybody have helpful suggestions, other than 1.
buy new remotes 2 buy newer vcrs
Thanks,
|
|
Jaszmin
Guest
|
| Posted:
Tue Oct 18, 2005 12:50 pm Post subject:
Re: Sanyo remote codes |
|
|
Move the machines out of the vicinity of one another,
so you can point and click with abandon. i have two
Sanyos that use essentially the same tones. I put the
timer on, on one, while using the remote on the other,
because with the timer on the one, it is impervious to
the remote. Of course, the timer has to be put on by
hand (by turning the power off) on the one, so that
is inconvenient. I have so much equipment with remotes
on it now, that I have to just rethink this stuff periodically,
but I have done that. I'm pretty comfortable with this.
Mike
On Fri, 22 Jul 2005 20:14:41 -0500, "retiredusarmy"
<retiredusarmyspambad@hotmail.com> wrote:
| Quote: | I was given two sharp vcrs this week. My Sanyo U100 remote operates them.
However, the Sanyo U110 does not operate them. Only three codes listed on
website 239, 229, and 224. Anybody have helpful suggestions, other than 1.
buy new remotes 2 buy newer vcrs
Thanks,
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in