| Author |
Message |
JT
Guest
|
 Posted:
Mon Nov 15, 2004 11:06 am Post subject:
Procoder 2 - progressive scan isn't in the interlace list |
|
|
I can't figure out how to turn on progressive scan in Procoder 2 (NTSC
DVD output). The old version had it at the top of the video interlace
list, but it's not there in V2. Must be some other setting that
disables it?
|
|
| Back to top |
|
 |
erratic
Guest
|
| Posted:
Mon Nov 15, 2004 6:01 pm Post subject:
Re: Procoder 2 - progressive scan isn't in the interlace lis |
|
|
On Sun, 14 Nov 2004 22:06:15 -0800, JT <NgPoster@missing.org> wrote:
| Quote: | I can't figure out how to turn on progressive scan in Procoder 2 (NTSC
DVD output).
|
Canopus_BH wrote this in the ProCoder forum: "If you switch the Stream
Type to Generic ISO MPEG, that'll allow you to choose progressive output
in the MPEG target." |
|
| Back to top |
|
|
JT
Guest
|
| Posted:
Thu Nov 18, 2004 10:01 am Post subject:
Re: Procoder 2 - progressive scan isn't in the interlace lis |
|
|
erratic <erratic@reply-to.address> wrote:
| Quote: | On Sun, 14 Nov 2004 22:06:15 -0800, JT <NgPoster@missing.org> wrote:
I can't figure out how to turn on progressive scan in Procoder 2 (NTSC
DVD output).
Canopus_BH wrote this in the ProCoder forum: "If you switch the Stream
Type to Generic ISO MPEG, that'll allow you to choose progressive output
in the MPEG target."
|
Thank you thank you thank you thank you! I assumed it was possible
because it's mentioned, but 'how' was left to the student. Now to find
out empirically if Generic ISO MPEG yields data that fits the DVD
standards. |
|
| Back to top |
|
|
|
|
|
|
Profile
Log in to check your private messages
Log in