DVD-Software.info

[Ben Stratford]

Mark,
Thers's a picture of one on the following link:
http://www.visi.com/~jweeks/stuff/pioneer/#SPEC
The drawer shuts ok, then the disc starts spinning, after 2 seconds o
spinning the drawer ejects again!
Ben

Mark D. Zacharias Wrote:

[Mark D. Zacharias]

Wow. This one predates my experience. I do think some cleaning and general
maintenance is where I'd start. Some older players had problems with belts
driving the clamping mechanism. Often dirty lenses, and bad lube on
wormscrews, or the belts driving them would go bad. Sometimes the laser is
just bad. This would be unfortunate, Pioneer might not even carry it
anymore. Some models later than yours had common problems with shorted
spindle motors, though I suspect yours, since it's older, might use a
direct-drive motor. Even these could have problems, though.

Mark Z.


"Ben Stratford" <Ben.Stratford.1j7qpt@news.audiobanter.com> wrote in message
news:Ben.Stratford.1j7qpt@news.audiobanter.com...