Introduction

Simple and quick guide to using dvddecrypter to rip an entire DVD to your computer, ready for software that cannot handle copyrighted DVD’s

Software Required

DVDDecrypter

Method

Run DVDDecrypter, and select settings. DoublAe check the settings are the same as in the snapshots below. This will ensure that all copy protection is removed, no region protection is present and any restrictions that were on the DVD have also been removed. These tend to be annoying features like forcing you to watch copyright messages, etc, etc.

If you get any errors message relating to the region being incorrect, simply change the RCE Protection Region to the source DVD region. For Europe/UK this is 2, for the USA this is normally 1.
 

NOTE

This is very important, otherwise the region coding will not be removed. So, if the DVD you are ripping is marked as Region 1, set this setting to Region 1, if its listed as Region 3, set it to Region 3

 

 

Put the DVD that you are going to rip into your DVD drive, run DVD Decrypter 

 Click mode, then tick file 

 It is best to select the whole movie, as the copy will not always work if only the Main movie and none of its support VOB files are present 

 In the destination directory box, enter the directory or volume where DVD Decrypter will rip the files 

 Click the big Decrypt button 

All the files will then be ripped to that directory, make sure you allow around 8GB for each DVD you are ripping especially if the source DVD is a dual layered DVD (DVD-9). These are normally DVD’s that have lots of special features, trailers and extras, or have more than about 100 minute run times