Part 6 - VCDEasy / CDRDao

Step 1 - To burn the newely created images, first make sure that the CDRDo is set up correctly, go to the "Settings " and select the "CDRDAO" menu item, make sure you select your " CD Writer" and set the speed, and also enable the "Allow Overburn " if you plan on using over 80min CDR media.

Step 2 - Next, go to the "Tools" section and select "CDRDao Tools" from the above menu, here you can "Blank a CDRW " and also select to "Burn a CUE or TOC CD Image" file, you can also select to "Simulate" and not actually burn. Press the " CUE/TOC file" button, and then select the Image you want to burn.

Step 3a - After you selected the first image of the movie (in this case Superman - VCD1.cue) then press the "Burn" button and the writing of the CD will start.

Step 3b - When you are done burning the first part select the second image of the movie (in this case Superman - VCD2.cue) and again press the "Burn" button and the writing of the CD will start.